Titre :

Continuous Monitoring of Whey Protein Fouling Using a Nonintrusive Sensor

Auteur(s) :

Bouvier, Laurent [Auteur]
Unité Matériaux et Transformations (UMET) - UMR 8207
Delaplace, Guillaume [Auteur]
Unité Matériaux et Transformations (UMET) - UMR 8207
Lalot, Sylvain [Auteur]
Laboratoire d'Automatique, de Mécanique et d'Informatique industrielles et Humaines - UMR 8201 [LAMIH]

Titre de la manifestation scientifique :

12th International conference on Heat Exchanger Fouling and cleaning

Ville :

Aranjuez

Pays :

Espagne

Date de début de la manifestation scientifique :

2017-06-11

Titre de la revue :

Heat Transfer Engineering

Éditeur :

Taylor & Francis

Date de publication :

2019-03-11

ISSN :

0145-7632

Discipline(s) HAL :

Physique [physics]/Matière Condensée [cond-mat]/Science des matériaux [cond-mat.mtrl-sci]
Physique [physics]/Matière Condensée [cond-mat]/Matière Molle [cond-mat.soft]
Sciences de l'ingénieur [physics]/Génie des procédés
Sciences du Vivant [q-bio]/Ingénierie des aliments
Sciences du Vivant [q-bio]/Biochimie, Biologie Moléculaire/Biologie moléculaire

Résumé en anglais : [en]

In this work, a nonintrusive device to monitor fouling of a plate heat exchanger is presented. This device is composed of a flat electrical resistance covering a thermocouple located on the external face of a tubular holding ...
Lire la suite >In this work, a nonintrusive device to monitor fouling of a plate heat exchanger is presented. This device is composed of a flat electrical resistance covering a thermocouple located on the external face of a tubular holding section. The tubular holding section is placed immediately after the investigated plate heat exchanger, constituting the heating zone for which fouling monitoring is required. The principle of detection consisted in following the evolution of the measured temperature with time when a fixed thermal heat flux imposed by the resistance is dissipated through the temperature sensor. The measured temperature is supposed to vary with time since the inner temperature on the inner surface of the holding tubular zone is linked to the fouling growth. It is shown that the device response is highly correlated to the fouling occurring in the plate heat exchanger and could be a promising way for monitoring fouling rate (cheap and easy to implement avoiding cleanability drawbacks).Lire moins >

Langue :

Anglais

Comité de lecture :

Oui

Audience :

Internationale

Vulgarisation :

Non

Établissement(s) :

Université de Lille
CNRS
INRA
ENSCL

Collections :

• Unité Matériaux et Transformations (UMET) - UMR 8207

Équipe(s) de recherche :

Processus aux Interfaces et Hygiène des Matériaux (PIHM)

Date de dépôt :

2022-02-01T10:38:02Z
2022-02-08T11:13:01Z
2022-05-05T14:40:28Z