Raman characterization of Mg<sup>+</sup> ion-implanted GaN

Boudart, B.; Guhel, Y.; Pesant, J.C.; Dhamelincourt, P.; Poisson, M.A.

Type de document :

Compte-rendu et recension critique d'ouvrage

DOI :

10.1088/0953-8984/16/2/006

Titre :

Raman characterization of Mg<sup>+</sup> ion-implanted GaN

Auteur(s) :

Boudart, B. [Auteur correspondant]
Laboratoire Universitaire des Sciences Appliquées de Cherbourg [LUSAC]
Guhel, Y. [Auteur]
Institut d’Électronique, de Microélectronique et de Nanotechnologie - UMR 8520 [IEMN]
Pesant, J.C. [Auteur]
Institut d’Électronique, de Microélectronique et de Nanotechnologie - UMR 8520 [IEMN]
Dhamelincourt, P. [Auteur]
Centre d'Etudes et de Recherches Lasers et Applications [CERLA]
Laboratoire Avancé de Spectroscopie pour les Intéractions la Réactivité et l'Environnement - UMR 8516 [LASIRE]
Poisson, M.A. [Auteur]

Titre de la revue :

Journal of Physics: Condensed Matter

Pagination :

S49-S55

Éditeur :

IOP Publishing [1989-....]

Date de publication :

2004

ISSN :

0953-8984

Résumé en anglais : [en]

Mg+ ions were implanted at room temperature in n-type hexagonal GaN for the device isolation purposes. The implantation dose varied from 7.5 × 1012 to 1016 ions cm-2. We performed resonance Raman spectroscopy and DC ...
Lire la suite >Mg+ ions were implanted at room temperature in n-type hexagonal GaN for the device isolation purposes. The implantation dose varied from 7.5 × 1012 to 1016 ions cm-2. We performed resonance Raman spectroscopy and DC electrical measurements in order to monitor the structural and electrical changes of non-annealed and annealed implanted GaN samples. Annealing was carried out at 900 °C for 30 s, these conditions being used to achieve good Ohmic contacts. The aim was to determine, on the one hand, the influence of ion doses on the device isolation and, on the other, to establish the order of the technological steps which should be made between ion implantation and Ohmic contact annealing. On increasing the implantation dose from 7.5 × 1012 to 2 × 1014 ions cm-2, an increase in the electrical isolation and a decrease in the photoluminescence (PL) were observed. For the highest dose, the implanted layer became conductive owing to a hopping mechanism and only the first-order phonon lines remained observable. After annealing, the implanted samples became conductive and the PL reappeared or increased compared with the non-annealed samples at same implantation doses, except for the sample implanted at the highest dose, which became insulating. Then, it is possible to achieve device electrical isolation by using a lower ion dose without thermal annealing or using a higher ion dose with thermal annealing.Lire moins >

Langue :

Anglais

Vulgarisation :

Non

Collections :

Institut d'Électronique, de Microélectronique et de Nanotechnologie (IEMN) - UMR 8520

Source :

Harvested from HAL

Raman characterization of Mg<sup>+</sup> ... BibTeX CSV Excel RIS

Raman characterization of Mg<sup>+</sup> ...

BibTeX

CSV

Excel

RIS